RPO 'L-HD' Launch Box

next >  • index •  < previous Pre-Drilling The Angle Iron
Launch Box, Grind Box, Skate Box

When drilling into steel, especially pipe or thicker plate steel, you should start by tapping a small indention where you want to drill the hole. This small indention will keep the drill bit from slipping and sliding all over the place. Use what you have to make the indention. Here we used an extra wood screw and a hammer. You can also use a nail countersink tap. Those won't buckle like the screw will!

RPO Launch Box, Grind Box, Skate Box Diagram tear

Jump to a Section: